Dyno Tuning & Can Am Engine Building

Wholesale ATV ® - Nations Largest Retail Powersports Distributor.. Multiple Locations Nationwide. Licensed, Bonded & Insured Powersports Dealership.

Our Metro Memphis Location has a 20000sq ft showroom with over 100 ATV's, UTV's, Dirt Bikes, Go Karts to choose from, Tires, Wheels, Lift Kits, Exhaust, Axles, ECU Flashes, DynoJet Dyno Tuning & Performance Engine builds, Clutches & Clutch Tuning, State Licensed Repair Shop...


We rebuild all Can-Am Rotax & Odes & CF-MOTO Engines For a Flat Rate of $250 + Parts, We also offer 840cc/860cc/975cc/1018cc/1020/1040cc/1105cc & 1180cc Big Bore kits as well as Dyno Tuning on our in house DynoJet ATV/UTV Dyno, 


For Instance:
If your engine is completely thrashed & needs, New Crank, Rods, Pistons/Rings, Cylinders up to 1040cc, Chains & Maverick Heads, Including all new Bearing, Gaskets we do it all for $1700. 

If you just need New Crank, Rods, Pistons/Rings, Cylinders, Including all new Bearing, Gaskets is $1250.

If is just a Basic rebuild including New Pistons/Rings, Cylinders, & all new Bearing, & Gaskets $800.

If you Just Sunk it & just need it taken apart, Inspected, cleaned & reassembled it is only $350 with gaskets, oil & filter.


All Rebuilds depend on what needs done, & nothing is done without a complete tear down & inspection, once rods, pistons, jugs, etc have been checked we will let you know what needs to be done or what is on the edge of operational tolerance & make recommendations, an average motor normally requires, crank, rods, pistons, cylinders, rings, bearings & gaskets, including oil filter & oil normal costs is $1295, as most people normally run them till crank is done or requires turning & oversized bearings or a whole new crank, turning cranks can be little bit cheaper but does takes a little bit longer to be done.



We also have a State of the Art DynoJet® ATV/UTV Dyno, $65 get you 3 runs with print out of Horse Power & Torque $15 more includes Wideband (Air/Fuel) Custom Tuning is priced on a hourly basis & is $65 per hour we also do clutch adjustments, if you recently added something, or just want to squeeze every bit of power you can out of it, give us a call. 

ECU Flashing Only!!! - $99 
We adjust Timing, Adjust Fuel Tables, Raise Rev Limiters, Raise Speed Limiters, Remove Torque Limiters, Gas & Brake limiters.

From Air/Fuel, Timing & Removing Limiters in factory Ecu we do it, & it's all done without having to open up your ecu box, we just plug rite in, Dyno Tuning will also include a before & after Dyno Graph, whether it's for fun or just Bragging rights we got you covered!!!.


We also offer the removal & installation of engines from your ATV or UTV for a Flat rate of $450 (By Appointment Only).


We do a lot of Polaris stuff like Lift Kits, Tender Springs, Exhaust, BOV's, Wheels/Tires, Clutches, ECU Flashing, Dyno Tuning as well w/ Wideband Air/Fuel.


We offer Lift kits, Wheels, Performance Exhaust & Dyno Tuning for all Makes & Models.


Here's a List of some of the companies we are dealers for:

Wheels & Tires: MSA, ITP, Maxxis, HighLifter, MudTrax, BKT, Gorilla, Interco, Carlisle, Super Swamper, Super ATV, Kanati, Pitbull, CST, GBC, Kenda, Slasher, KingWonder, Pro-Comp, Far East, Wanda, Sedona, Essex, STI, HD, SS, etc, etc

HMF & Two Brothers Exhaust

Turner Cycle Axles

Catvos Lifts

Highlifter

Super ATV

Dynojet Power Commander PCV & Power Vision CX



Located 15 Minutes from Downtown Memphis.


Wholesale ATV
4030 Austin Peay Hwy
Memphis, TN 38128

Hours:
Open (7) days a Week!!!
Monday - Sunday 10am-6pm


Credit Cards Accepted & Financing Available


Any questions call (901) 654-8129